RouterA1(config)# interface gigabitEthernet 0/1 RouterA1(config)# interface gigabitEthernet 0/0 RouterA1 Interface Configuration RouterA1(config)# interface loopback 0

Acording to my basic IP plan, I used the below IPs for my interfaces.ĥ0.0.0.2 Interface Configurations for Packet Tracer BGP Configuration To do this, as a better network engineering rule, firstly make your IP plan or, use the existing one. The topology that we will be used for our BGP Config is below:įor Packet Tracer BGP Configuration, firstly we need to configure the IP addresses of interfaces as other examples. You can also test yourself with BGP Tests and Questions. pkt format in Packet Tracer Labs section. You can also DOWNLOAD all the Packet Tracer examples with. You can DOWNLOAD the Packet Tracer example with. We will use the Private AS block (64512 to 65535) for this configuration, but in internet public AS numbers are used. In the configuration we will use two AS (Autonomous System) with 3 routers for each.

Beside this, I will add some additional cofiguration steps that is needed for IBGP but we can not config ure on Packet Tracer. Because of the limited numbers of commands available on Packet Tracer, we will practice a very basic configuration for our BGP Config Example. To understand BGP (Border Gateway Protocol) better, we will make a basic Packet Tracer BGP Configuration example. BGP Configurations for Packet Tracer BGP Configuration.Interface Configurations for Packet Tracer BGP Configuration.Packet Tracer BGP Configuration Example.

Cisco packet tracer topology examples